 |
At RR Racing, we are always looking for ways to combine
functional performance modifications with aesthetic enhancements. Nothing says, “Race Car,” more than a functional tubular chassis brace!
While other braces are often made from cheap aluminum or
feature overly complicated 3-piece designs that do not enhance chassis
stiffness, our chassis braces are made from steel tubing with
multiple cross members reinforcing a wide cross-member for maximum lateral and
torsional stiffness. This is the same design you will find on many purpose-built
race cars!
It also happens to look pretty darn good, which is
why we offer it in a choice of custom powder coated colors! Additionally, we
offer an optional real carbon fiber laminate covering over the center tubes for
that added touch of contrast and detail!
Please refer to the following color codes for color options:

Important Disclaimers:
If you are not sure of the above color options, please contact us. We cannot guarantee your satisfaction with the selected color, and we cannot redo the color once the product is shipped.
Please also note that this is a hand-made product, which main purpose is to improve performance. There may be slight color variations and imperfections in the powder coating. Our goal for the brace to look nice once installed when looking at the engine bay, not when looked at very closely.
Because this brace has 8 bolt-on points and a close tolerance functional design, it may be more difficult to install than a typical non-functional bar brace. On some cars, the installer may need to jack one side or both front sides of the vehicle to let the suspension top plates settle in the correct position allowing proper brace installation.
Please note that this brace does not fit RHD cars. The flange connecting the brace to the firewall needs to be modified to fit.
|
|
 |